Brewology

hmm..ive been getting the no code found (-1) error for ages now, but suddely:
ta-ta:

found boot.elf!
read sector 5069 (or something similar)
then read sector line disappears and

err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000
err=c1000002, reply=80400900 0000000 0000019e 90010000

im using the eu save file and the homebrew from the generator and have varied formatting sd with xp and dedicated software. the card im using is a panasonic 16MB.

what the fugg?

what boot.elf are you using? What are you trying to do?

sorry:

I`m trying to install the Homebrew Channel.

I downloaded the EU Twilight hack, and the hombrew boot.elf from the generator and i have followed guide down to fingertips.

..

I'm getting the same thing. I have a US Wii, the US version of Twilight Princess, and I downloaded the US version of the Hack.

I get the error c1000002s scrolling for about a minute until I get a "cannot load, hung" message, and I have to hold the power button for several seconds to power it down.

I downloaded the installers from the web site today. I have the 3.3U version of Wii installed.

Thanks.

Sorry, been MIA for a while...

Honestly, I dunno what to tell you. As long as you have everything in the right place, it should work. I'd refer you to http://wiibrew.org/wiki/Homebrew_Channel/Bugs and post about it there.

Is anything written to the SD card during this process? The only SD card that I have to use is a 32meg chip that came with my phone. Might this cause it? I notice that the original poster is using a small capacity card as well.

I plan on buying a 1 or 2 gig card and trying it again soon, to see if I get the same problem.

I don't want to use my current 2 gig card that I use for savestates in doing this.

Thanks.

---
UPDATED:

I backed up my 2 gig card and installed the hack onto it to try to install the homebrew channel. That worked! So the install must require a large enough card to do the install.

So, I got the homebrew channel to install, but I'm having other problems with it. I won't go into that here, I'll start a new thread.

Thanks again